Jet Propulsion for hydrofoil or maybe a prop and flex shaft

| |
Very cool control system



The drive with the angle reduced improves losses 20% 4.3 Amps idling so only 300mA losses from the shaft. I think the steering should be integrated as a kitchen rudder behind the prop.




Reversing the shaft on a Turnigy D3542/4 Aero drive It a 1450 KV and should deliver loads of torque at 14,000 RPM on as 3C



Battery: 2~4 Cell /7.4~14.8VRPM: 1450kvMax current: 48A No load current: 4AMax power: 690WInternal resistance: 0.019 ohmWeight: 130g (including connectors)Diameter of shaft: 5mmDimensions: 35x42m



Above is a 47 mm prop I have a 57 to once I have the motor attached to the shaft sleeve I will do a power test in a tank see what thrust and Amps I get. With the fat end of 1 HP it should have plenty of clog to lift  it up on the foils.




The shaft is running in a good quantity of copper slip. Ran it on a 4C for a minute an the brass only got warm.



I think the body of the hydrofoil will be a lunch box. I think I will have the prop shaft attached to the rear foil

Perhaps the prop on the above can be placed in a tube like these designs



An interesting jet outboard very high outlet must cost power




Jet Propulsion for hydrofoil  





One thing as there is no transom the bulky scroll will always be in the flow and the outlet will be under water which will reduce the trust considerably.


If the outlet was up high it would work better also the riser would need to be streamlined







Or what about an EDF pumping air into a venturi like below





Related Posts by Categories

0 komentar:

Posting Komentar